User`s guide

RAELink3 User’s Guide

If you see this screen when you turn on the RAELink3 Remote, then

you must turn on the Bluetooth. See page 26 for details that cover

turning Bluetooth on and off.

BT Power Off

When Bluetooth is on and a link to a Bluetooth device is established,

you see this screen (otherwise, you see “No Record” or “Power Off”):

Note: If the RAELink3 is new and/or has never established a

connection before, the display shows this message, indicating that no

ID number has been previously stored:

The RAELink3 can scan for Bluetooth-enabled monitors, and stores

up to 2 connections in memory for faster re-deployment.

Follow these steps to connect a RAELink3 to a monitor via

Bluetooth:

1. Turn on the Bluetooth-enabled monitor. Make sure it is set up

to run Bluetooth (Bluetooth is turned on).

2. Turn on the RAELink3. It should be in Remote Mode, and

Bluetooth turned on.

Important! If you are re-pairing the RAELink3 with the

primary Bluetooth detector in its memory (indicated by an