User`s guide

RAELink3 User’s Guide

12.7 Setting The Unit ID

Each Remote Unit in an AreaRAE network must be assigned a unique

Unit ID (between 00 and 99). Make sure that the unit ID is not

duplicated among any of the Remote units within the same AreaRAE

network.

Note: Sometimes the Unit ID is set on the remote monitor (for example,

on a MiniRAE3000 or MultiRAE Plus), and sometimes it is set on the

RAELink3 attached to a monitor (such as a GammaRAEII R).

Note: When RAELink3 is configured as a Repeater or Host, it does

not require a Unit ID. Therefore, the Set Unit ID Menu is not

applicable in this mode.

When RAELink3 is configured as a Remote, the Set Unit ID menu

screen looks like this:

Unit ID: 01

Change?

Press [Y/+] if you want to change the Unit ID. When changing the

Unit ID, the cursor flashes on the selected digit, highlighting it and

indicating that you can change it:

Unit ID: 01

1. Press [Y/+] to increase the number or [N/-] to decrease the

number.

2. Press [MODE] to advance to the next digit.

3. Input a Unit ID (00 through 99).