User guide
Mesh Router User’s Guide
10 “Panic” Function
The Mesh Router has a “Panic” function, where you can manually trigger
the relays at the main FMC2000 controller in the network. This must be
configured in the Mesh Router in advance. This function allows you to
trigger any individual relay or all relays simultaneously.
10.1 Enabling/Disabling The “Panic Button”
Function
Note: By default the “Panic Button” function is disabled.
1. Start the Mesh Router in Diagnostic mode by pressing and
holding the [Y/+] and [MODE] keys simultaneously.
2. Once startup is completed and the main screen is shown, enter
Programming mode by pressing and holding [MODE] and [N/-]
simultaneously.
3. Provide the 4-digit password and press [Y/+] to enter it.
Note: The default password is “0000.”
This screen appears:
4. Press [N/-] until “Operating Mode” is highlighted.
5. Press [MODE] to select “Operating Mode.”
“Panic Enable” or Panic Disable is highlighted.
or
32