User guide

Mesh Router User’s Guide

Note: If you perform a factory reset, all of your settings are removed and

cannot be retrieved.

9.1.5 Edit Password

You can change the password by selecting “Edit Password.”

At this screen, input your new password over the old one (or the default):

• Increase the number from 0 through 9 by pressing [Y/+].

• Decrease the number from 9 through 0 by pressing [N/-].

• Step from digit to digit using [MODE].

Note: If you make a mistake, you can cycle through the digits by

pressing [MODE] and then using [Y/+] and [N/-] to change the number

in each position.

Once all the four digits have been entered, press [MODE] again to see

the following screen appear.

• Save your changes by pressing [Y/+].

• Exit without saving changes by pressing [N/-].

• Step back to the first digit by pressing [MODE].