User guide

Mesh Router User’s Guide
9 Programming The Mesh Router
Programming Mode is accessed by first providing the correct password.
Press and hold [MODE] and [N/-] until you see this screen:
Input the 4-digit password:
• Increase the number from 0 through 9 by pressing [Y/+].
• Decrease the number from 9 through 0 by pressing [N/-].
• Step from digit to digit using [MODE].
Once all the four digits have been entered, press [MODE] again to
see the following screen appear. Press [Y/+] to enter the password.
If you make a mistake, you can cycle through the digits by
pressing [MODE] and then using [Y/+] and [N/-] to change the
number in each position.
Note: The default password is 0000.
If your password is incorrect, you see this screen:
After a few seconds, the Mesh Router exits to its main screen.
19