User guide

EchoView Host User’s Guide

8.2.1 Ping Net

Pinging tests the radio connection between the EchoView Host and other

units on its network. (A “ping” is a short signal sent to the network to

prompt a reply; it contains no other data.)

Scroll until “Ping Net” is selected.

Press [MODE] to ping the network. This message appears:

Press [Y/+]. The Echoview Host broadcasts a ping signal to its network.

All devices in the network that receive the ping signal respond with a

beep if they are within the range. (The Echoview Host does not beep or

flash its LED lights.) You can also ping from an instrument in the

network. If it is within range, the EchoView Host responds with a beep

and an LED light flash.

If a network ping is unsuccessful, check the following:

• Is the antenna attached?

• Does the PAN ID match the PAN ID of other instruments in the

network?

• Does the Channel match the channel on which the other instruments

are operating?

• Are the other instruments turned on and within range?