Data Sheet

Honeywell Confidential and Proprietary Revision –3.0 Page 14 of 14
Copyright © 2021 Honeywell Analytics, All rights reserved.
10. The requirement for KDB 996369 D03
1 List of applicable FCC rules
FCC Part 15. 247.
2 Summarize the specific operational use conditions
None.
3 Limited module procedures
The module is a single module, so this requirement is not applicable to the product.
4 Trace antenna designs
NA.
5 RF exposure considerations
After evaluation, the SAR requirement is deemed to be satisfied without test. Please check the report
for detail information.
6 Antennas
Antenna 1: -0.32dBi, FPC antenna
Antenna 2: 3.0dBi, dipole antenna
Antenna 3: 3.0dBi, dipole antenna
Antenna 4: 3.0dBi, dipole antenna
Antenna 5: 1.8dBi, dipole antenna
7 Label and compliance information
If this certified module is installed inside the host device, then the outside of the host must be labeled
with “Contains FCC ID: SU3RMLORAB and IC: 20969-RMLORAB”.
8 Information on test modes and additional testing requirements
The host manufacturer can use the software of SSCOM V5.13.1 to make the transmit continuously.
9 Additional testing, Part 15 Subpart B disclaimer
The module only complies with the FCC Part 15.247. If the module is installed in the host device, the
host manufacturer is responsible for the compliance to any other FCC rules that apply to the host not
covered by the modular transmitter grant of certification. For example, if the host manufacturer
markets their product as being Part 15 Subpart B compliant (when it also contains unintentional-radiator
digital circuity), then the host manufacturer shall provide a notice stating that the final host product still
requires Part 15 Subpart B compliance testing with the modular transmitter installed.