User's Manual

For Internal Use Only
2) How to embed RAELoader_ATMega1281
If you want to embed bootloader into RM900 or RM2400A which use ATMega1281 as mcu, no matter Atmel
bootloader or RAELoader, you should prepare corresponding tool.
Software: AVRUSB V2.0.2.231
Hardware: AVRUSB Programmer and RAEMeshII Dev board.
Then, operate step by step as below,
a) Make sure the correct hardware selected
b) Make sure the AVRUSB connected to dev board and board is power on, click “Reset”.
If a green label is at bottom of AVRUSB framework, go to next step.