User's Manual

For Internal Use Only
GET_PARENT_ID Use on: RTR STD
RM RMII
0x68 None 0x69 Parent radio ID(8) 0x00 00 00 00 00 00 00 00 means that STD or RTR’s parent
is coordinator/gateway. 0x00 00 00 00 00 00 mm nn means STD or RTR’s parent is a RTR which short address is mm nn. 0x00 00 00 00 00 00 ff fe means that STD or RTR do not have parent.
LAST_HOP_RSSI Use on: RTR STD
RM RMII RW
0x7B None 0x7C RSSI(1) Get RSSI percent, the higher, the better.
Best: 240 Worst:0 RTR get next hop rssi; STD get parent rssi.
SET_RECEIVER Use on: STD
RMII 0xA0 00 - Disable
01 - Enable
0xA1 None Enable or disable STD’s receiver.
STD should receive data packet from parent if enable receiver; STD should use poll to request data packet from parent if disable receiver. Reset automatically.
GET_RECEIVER Use on: STD
RMII 0xA2 None 0xA3 Status(1) Return STD receiver’s status,
00 – Disable 01 - Enable
SET_REGION Use on: GTW RTR STD
RMII 0xA4 Region(1) 0xA5 None For RMII
Region(1) BAND_868_EU = 0x01, BAND_915_NA = 0x04, BAND_2400_ISM = 0x08, When 2.4Ghz modem, this command is useless because RM2400 always work on BAND_2400_ISM. When 915/868Mhz modem, default channel is 0x00 if set region to BAND_868_EU; default channel is 0x06 if set region to BAND_915_NA. Reset automatically.