User's Manual

RAEMesh2 RMCI Protocol
Doc.No.
904-E800-316
Rev.No.
A
Date: 10/14/10
Page
21
of
9
Terms:
GTW: A RTR used for gateway. Only one GTW per network.
RTR: Full Function Device. Sensor node with routing ability. RTR requires line power all time.
STD: Reduce Function Device. A Sleeping node can only talk to a RTR or GTW. Can not relay the message. Can be a
battery powered device.
RCM :Radio Communications Module
RDTE: Reader Data Terminal Equipment.
RMCI: RAEMesh Module Command Interface.
SDTE : Sensor Data Terminal Equipment.
Reference:
Atmel: www.atmel.com
FCC: www.gcc.gov
Zigbee Alliance: www.zigbee.org
Contact:
Disclaimer
Product and Company names and logos referenced may either be trademarks or registered trademarks of their respective
companies. We reserve the right to make modifications and/or improvements without prior notification. All information is
correct at time of issue. RAE Systems does not convey any license under its patent rights or assume any responsibility for
the use of the described product.
Warnings:
FCC Notifications:
Compliance Statement (Part 15.19)
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference received, including interference
that may cause undesired operation.
2. This device must accept any interference received, including interference that may
cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device must be operated as supplied by Raesystems. Any changes or
modifications made to the device can be jeopardize, but there is one
exception. The radio’s antenna can be replaced as long as the specification of the
antenna matches the original.
Information for the OEMs and Integrators
This device is intended for OEM integrators only. Please see the full Grant of Equipment document for restrictions.
This device must be operated and used with a locally approved access point.
Label Information to the End User by the OEM or Integrator
If the FCC ID of this module is not visible when it is installed inside another device, then the
outside of the device into which the module is installed must be labeled with "Contains FCC ID:
SU3RM2400A" in a visible area.
To satisfy FCC RF exposure requirements, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended.
MPE reminding