User's Manual

RAEMesh2 RMCI Protocol
Doc.No. 904-E800-316 Rev.No. A
Date: 10/14/10
Page
14 of 9
For Internal Use Only
GTW
RTR
STD
Power(1)
PAN ID(2)
GET_APPNODE_I
NFO
Use on:
GTW
RTR
STD
Both 0x6C None 0x6D UID(8)
Channel(1)
Power(1)
PAN ID(2)
Get the application information:
UID, Channel, Power, PAN ID. If
the network is not connected, the
GET_NODE_INFO will return
wrong information, and then use
this to get what we set.
GET_PARENT_ID
Use on:
RTR
STD
Both
0x68 None 0x69 Parent radio
ID(8)
0x00 00 00 00 00 00 00 00
means that STD or RTR’s parent
is coordinator/gateway.
0x00 00 00 00 00 00 mm nn
means STD or RTR’s parent is a
RTR which short address is mm
nn.
0x00 00 00 00 00 00 ff fe means
that STD or RTR do not have
parent.
LAST_HOP_RSSI
Use on:
RTR
STD
Both 0x7B None 0x7C RSSI(1) Get RSSI percent, the higher, the
better.
Best: 240
Worst:0
RTR get next hop rssi;
STD get parent rssi.
SET_DEBUG_PRIN
T
Use on:
GTW
RTR
STD
Both 0xFE 00,Disa
ble
01,Enab
le
0xFF None Set display debug information
enable/disable.
The default setting is disabled.
GET_FWVERSION
Use on:
GTW
RTR
STD
Both 0x4C None 0x4D Fw Version
and Build
Time[30]
Return fw version and build time,
for example
[BMv1.00 Feb 14 2011
10:11:11], this mean fw version is
V1.00 and build is on Feb 14
2011 10:11:11.
SET_CMDBATCH
Use on:
GTW
RTR
STD
RAEMeshII 0xAC 00,
Disable
01,
Enable
0xAD None Enable or disable command
batch function. If enable, modem
will not reset automatically after
change panid, channel, power,
eui, region and receiver. They will
take effect after reset manually.
Batch function will disable after
reset.
GET_CMDBATCH
Use on:
GTW
RTR
STD
RAEMeshII 0xAE None 0xAF 00,
Disable
01,
Enable
Return command batch
configuration.