User's Manual

RAEMesh2 User Manual
Doc.No:
Originator: kren
Page 6 of 21
Data: 2014-3-18
The Wakeup pin must be held up to 10ms before sending a data packet.
Power
Ground: Pin1, Pin2 and Pin4.
VCC: Pin39, Pin40. 3.0V or 3.3V
Heartbeat
Connect Pin12 to a LED for heartbeat indicator.
Reset.
RST: Pin3 Active Low.
PC communication
Please has your serial port debug software installed on the PC. For example: sscom32.exe
Microsoft Hyper Terminal is not recommended for this application because it is not good to send characters and
commands in Hex.
Base on correct setting and connection, you will see following display on your screen when power is applied.
GTW:
[%A]RAEMESH-II RM2400 8MHz
FwVer:V1.02b on Sep 28 2011 09:52:14
Stack: BC1.10.0
Type: Coordinator/Gateway
Band: 2400
EUI: 0001002400001005
Channel: 0x10
TxPwr: Medium
PanId: 0x03E5
RTR:
[%A]RAEMESH-II RM2400 8MHz
FwVer:V1.02b on Sep 28 2011 09:52:14
Stack: BC1.10.0
Type: FFD/Router
Band: 2400
EUI: 0001002400001005
Channel: 0x10
TxPwr: Medium
PanId: 0x03E5
STD
[%A]RAEMESH-II RM2400 8MHz
FwVer:V1.02b on Sep 28 2011 09:52:14
Stack: BC1.10.0
Type: RFD Sleep Sensor
Band: 2400
EUI: 0001002400001005
Channel: 0x10