User Manual

63
PGM2600 Marking
The PGM-2600 is certified according to the IECEx scheme, ATEX and CSA for US and
Canada as protected by intrinsic safety.
The PGM-2600 is certified according to the IECEx scheme, ATEX and CSA for US and
Canada under the intrinsic safety method of protection.
The PGM-2600 is marked with the following information:
RAE SYSTEMS
3775 N. 1
st
. St., San Jose
CA 95134, USA
Type PGM-2600.
Serial No/barcode: XXXX-XXXX-XX
IECEx SIR
15.0039X
Ex ia d IIC T4 Gb
Ex ia I Ma
0575
SIRA 15 ATEX 2080X
II 2G Ex ia d IIC T4 Gb
I M1 EX ia I Ma
Cl.I Dv 1, Grps A,B,C,D T-Code T4.
C22.2 No.152-M1984
ANSI/ISA-12.13.01-2000
Intrinsically safe/Sécurité intrinséque
Applied standards (ATEX-IECEx)
IEC 60079-0:2011
IEC 60079-1:2014-
06
IEC 60079-11:2011
EN 60079-
0:2012/A11:2013
EN 60079-1:2014
EN 60079-11:2012
See list for applied requirements for
cCSAus in the table below.
APPLICABLE REQUIREMENTS (cCSAus)
CAN/CSA-C22.2 No. 60079-0:2011
(IEC 60079-0:2007, MOD)
Explosive atmospheres — Part 0: Equipment — General requirements
CAN/CSA-C22.2 No. 60079-11:2014
(IEC 60079-11:2011, MOD)
Explosive atmospheres — Part 11: Equipment protection by intrinsic
safety “i”
CAN/CSA-C22.2 No. 30-M1986
Explosion-Proof Enclosures for Use in Class I Hazardous Locations
CAN/CSA-C22.2 No. 152-M1984
Combustible Gas Detection Instruments
CAN/CSA C22.2 No. 61010-1-12
Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use - Part 1: General Requirements - Third
Edition
UL 60079-0:2013 (6th Ed.)
Explosive atmospheres — Part 0: Equipment — General requirements
UL 60079-11:2013 (6th Ed.)
Explosive atmospheres — Part 11: Equipment protection by intrinsic
safety “i”
UL 913 (7th Ed.)
Intrinsically Safe Apparatus and Associated Apparatus for Use in Class
I, II and III, Division 1, Hazardous Locations
UL 1203 (4th Ed.)
Explosion-Proof and Dust-Ignition-Proof Electrical Equipment for Use
in Hazardous (Classified) Locations
ANSI/ISA 12.13.01-2000
Performance Requirements for Combustible Gas Detectors
ANSI/ISA-61010-1 (3rd Ed.)
Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use - Part 1: General Requirements - Third
Edition