User Manual

Once you enter Programming Mode, the Calibration screen is shown. Press [MODE] to step

through the programming screens.

9.2. Enter Programming In Advanced Mode

To enter Programming Mode, press and hold [MODE] and [Y/+] until you see the Calibration

screen. No password is necessary in Advanced Mode. Note: Some parameters can only be viewed

or changed in ProRAE Studio II.

9.3. Menus And Submenus

In Programming Mode, menus and submenus are organized as shown here:

Calibration

Sensor On/Off

Clear

Datalog

Monitor Setup

Set Radio

Single Bump

Sensor 1 On/Off

GPS On/Off*

BLE On/Off

Single Zero

Sensor 2 On/Off

Set Site ID

WiFi On/Off**

Single Span

Sensor 3 On/Off

Set User ID

Sent History**

Multi Bump

Sensor 4 On/Off

Mesh Roaming Enable***

Fresh Air Cal

Radio On/Off***

Multi Span

Set PAN ID****

Exit

Set Channel****

Join Network****

Factory Reset****

Exit

* GPS-equipped version only.

** WiFi-equipped version only.

*** Mesh Wirelessly equipped version only.

**** Only available if Roaming is turned off.