Specifications

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol Remote Operations
MN-DMDREMOTEOP Revision 9 1–69
<2> RFM AGC Time
Constant
1 - 99999 in ms
<1> Carrier-in-Carrier 0 = Disabled, 1 = Enabled
<2> Carrier-in-Carrier
Minimum Search
Delay
0 – 330
<2> Carrier-in-Carrier
Maximum Search
Delay
0 – 330
<1> Carrier-in-Carrier
Frequency Offset
Range
0 – 30 (KHz)
<1> EBEM overhead
channel rate
0 = Off, 1 = 8K, 2 = 16K, 3 = 24K, 4 = 32K, 5 = 40K, 6
= 48K, 7 = 56K, 8 = 64K
<1> EBEM embedded
channel
0 = Off, 1 = On
<1> EBEM ITA 0 = Disabled, 1 = Enabled
<1> EBEM encryption 0 = Disabled, 1 = Enabled
<4> EBEM Ethernet rate 4800 to 52000000
Opcode: <2A01h> Command a Demodulator’s Frequency
Command Data (4 Bytes)
<4> Frequency Selects the IF Frequency in Hz, IF Range = 50 MHz to
180 MHz, L-Band Range = 950 MHz to 2050 MHz
Opcode: <2A02h> Command a Demodulator’s Data Rate
Command Data (4 Bytes)
<4> Data Rate Binary value, 1 bps steps
2.4 Kbps to 20 Mbps for DMD20, DMD20LBST and
OM20
2.4 Kbps to 52 Mbps for DMD2050, DMD2050E and
DMD50
Opcode: <2A03h> Command a Demodulator’s Strap Code
Command Data (2 Bytes)
<2> Strap Code Binary value
Opcode: <2A04h> Command a Demodulator’s Sweep Boundary
Command Data (1 Byte)
<1> Sweep Boundary
Sweep limits. Max of

255 kHz in kHz steps 0 – 255
Opcode: <2A05h> Command a Demodulator’s Sweep Delay
Command Data (2 Bytes)
<2> Sweep Delay Binary value, 0.1 second steps, Implied decimal point,
0 – 65535 (0.0 sec to 6553.5 sec)
Opcode: <2A07h> Command a Demodulator’s Demodulation Type