Technical information

MM200 High-Speed Microwave Modem User Interfaces
TM086 - Rev. 4.1 4-41
Figure 1.
1. Verify that your emulation software is set to the following:
VT100
9600 baud
8 data bits
no parity
1 stop bit
Modify the MM200 selection, if necessary, to match the settings (the Front Panel
‘SYSTEM’ Sub-Menu contains all the Terminal Emulation Controls).
2 If the system is set up properly and the terminal fails to come up, verify that the Terminal
Cable (CA/3448-6) is attached properly from the Back Plate (J2) to the Header (J9) on the
Main M&C Card (AS/4458).
3. Switch S3 settings should be set as follows:
SW1: On
SW2: On
SW3: Off
SW4: Off