Technical information

User Interfaces MM200 High-Speed Microwave Modem
4-12 TM086 - Rev. 4.1
PRESS CLR TO
CENTER BUFFER
VOLUME
BYTE GAP
Centers the buffer.
{0 - 255}
Allows the user to set volume level
(Orderwire only).
Note: Only appears when supported
by the installed interface.
{0 - 255}
Allows the user to set ASI byte gapping.
Set to 0 for Burst mode. (ASI Interfaces
that support Byte Gap only).
RW
RW
RW
RX INTRFC2
Receive Interface 2. Refer to RX
INTRFC1 (menu) for descriptions.
RX INTRFC3
Receive Interface 3. Refer to RX
INTRFC1 (menu) for descriptions.
RX INTRFC4
Receive Interface 4. Refer to RX
INTRFC1 (menu) for descriptions.
4.4 All Level Menu Screens
4.4.1 Main Menu Screens
Main Menu Screens (one of which is a Title Screen) are listed below:
MM-200 MODULATOR Title Screen:
Not a modifiable screen.
MODULATOR (menu):
DEMODULATOR (menu):
REPEATER (menu):
APC (menu):
TX INTERFACE (menu):
RX INTERFACE (menu):
MONITOR (menu):
ALARMS (menu):
SYSTEM (menu):
TEST (menu):
4.4.2 MODULATOR (menu) *
The Modulator Menu Screens are listed below:
Screen Name Selections and Descriptions L0 L1 L2
FREQUENCY (Hz) {50 – 90 MHz}
Controls the current center band of the
RW
RW
RW