Specifications

DMD20/20LBST Universal Satellite Modem TCP/IP Ethernet Setup
MN-DMD20-20LBST Revision 14 E–4
The Computer TCP/IP must be properly configured in order to obtain connectivity. The following
set-up procedure can be used as a guide to aide in this setup. The following instructions apply
only to Windows 2000 or XP Classic.
1. Click on the Start Button. Select Settings and click on the Control Panel Icon. Double
click the Network Connections Icon.
2. Select the Local Area Connection icon for the applicable Ethernet adapter. Usually it is
the first Local Area Connection listed. Double click the Local Area Connection. Click on
the Properties icon.
Local Area Connection Status Box
3. Make sure that the box next to the Internet Protocol (TCP/IP) is checked. Highlight
Interconnect Protocol (TCP/IP) and click on the Properties button.
Local Area Connection Properties Box
4. Select “Use the following IP Address”. Enter in the IP Address that is offset by 5 or so
numbers from the equipment address (the computer and the equipment that it is connecting
to cannot have identical addresses) and Subnet Mask ( this is identical to the subnet mask
programmed into the equipment) into the corresponding fields. Click the OK button to