Specifications

DMD20/20LBST Universal Satellite Modem User Interfaces
MN-DMD20-20LBST Revision 14 4–43
Only the appropriate of the VCO adjustment screens listed below will be
displayed. These are protected fields, to prohibit accidental changes. To
edit the field, the user must depress all four of the direction arrow keys
simultaneously.
INT VCO ADJUST {0% - 100%}
Allows the user to adjust the internal frequency reference for
calibration. Only displayed of the system reference clock is
INTERNAL.
HI STAB VCO ADJUST {0% - 100%}
Allows the user to adjust the internal frequency reference for
calibration. Only displayed if the system reference clock
source is HI STABILITY.
LARGEST HB GAP Used for factory test only.
SOFT RESET {Enter}
IF BOARD (menu) Indicates the Radyne part number for the IF Board Assembly.
AGC/CTRL/VALUE {0% - 100%}
Allows the user to adjust the internal frequency reference for
calibration. Only displayed if the system reference clock
source is HI STABILITY.
I OFFSET Used for factory test only.
Q OFFSET Used for factory test only.
IF RX LVL OFFSET Used for factory test only.
LB RX LVL OFFSET Used for factory test only.
POWER SOURCE Used for factory test only.
TERR INTFC BRD Indicates the Radyne assembly number for the Terrestrial
Interface Assembly.
CODEC BOARD (menu) Indicates the Radyne part number for the Codec Board.
TPC FPGA IMAGE Used for factory test only.
TPC CODEC IMG Used for factory test only.
LDPC CODEC IMG Used for factory test only.
RS FPGA IMAGE Used for factory test only.
TPC CODEC IMAGE Used for factory test only.
FRONT PANEL BOARD Indicates the assembly number for the front panel board.
CNC BOARD (menu) Indicates the Radyne part number for the CNC Board.
DEBUG MODE {ENABLED, DISABLED}
IMPORTANT