Specifications

DMD20/20LBST Universal Satellite Modem User Interfaces
MN-DMD20-20LBST Revision 14 4–26
TOTAL PACKETS Displays the total number of Ethernet packets received from the
satellite (Only visible when Ethernet is selected as the
interface type).
ERROR PACKETS Displays the number of error Ethernet packets received from the
satellite (Only visible when Ethernet is selected as the
interface type).
PKT ERROR RATE Displays the satellite Packet Error Rate (Only visible when
Ethernet is selected as the interface type).
PKT STATS RESET Allows the user to reset the Ethernet packet statistics by
pressing <Enter> (Only visible when Ethernet is selected as
the interface type).
LINK STATUS (menu) (the following sub-menus only display when Ethernet is
selected as the interface type)
The status of the following ports may be one of the following:
Down: The link is down.
Unresolved: Unable to agree on connection speed.
10 Mbps Half: Connected at 10 Base-T Half Duplex.
10 Mbps Full: Connected at 10 Base-T Full Duplex.
100 Mbps Half: Connected at 100 Base-T Half Duplex.
100 Mbps Full: Connected at 100 Base-T Full Duplex.
Unused: The port is not available.
JS1 PORT {See the note above}
Displays the current status of the LAN Port.
JS2 PORT {See the note above}
Displays the current status of the LAN Port.
JS3 PORT {See the note above}
Displays the current status of the LAN Port.
JS4 PORT {See the note above}
Displays the current status of the LAN Port.
WAN STATUS {See the note above}
Displays the current status of the WAN Port.
VOLTAGES (menu)
+1.5V RX SUPPLY Displays the measured voltage of the 1.5 Volt Rx power bus
located inside the modem.
+1.5V TX SUPPLY Displays the measured voltage of the 1.5 Volt Tx power bus
located inside the modem.
+3.3V SUPPLY Displays the measured voltage of the +3.3 Volt power bus
located inside the modem.
+5V SUPPLY Displays the measured voltage of the +5 Volt power bus located
inside the modem.
IMPORTANT