Operating instructions

DMD20/DMD20 LBST Universal Satellite Modem User Interfaces
TM103 – Rev. 2.8 4-45
SOFT RESET {Enter}
IF BOARD (menu) Indicates the Radyne part number for the IF Board
Assembly.
AGC/CTRL/VALUE {0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
I OFFSET Used for factory test only.
Q OFFSET Used for factory test only.
IF RX LVL OFFSET Used for factory test only.
LB RX LVL OFFSET Used for factory test only.
POWER SOURCE Used for factory test only.
TERR INTFC BRD Indicates the Radyne assembly number for the
Terrestrial Interface Assembly.
CODEC BOARD (menu) Indicates the Radyne part number for the Codec Board.
TPC FPGA IMAGE Used for factory test only.
RS FPGA IMAGE Used for factory test only.
TPC CODEC IMAGE Used for factory test only.
FRONT PANEL BOARD Indicates the Radyne assembly number for the front
panel board.
ODU - BUC (menu) Indicates information from BUC via FSK.
SERIAL NUMBER Indicates the Serial number of the BUC when
supplied by the BUC via FSK.
ID INFO Indicates the BUC ID when supplied by the BUC via
FSK.
FSK DEBUG IMAGE 0x00D669E5
FEATURES (menu)
5012.2840.2417 {____.____.____}
Allows the user to install purchased feature upgrades
(see Appendix A).
Contact the Radyne Customer Service Department or
Sales for hardware and software upgrades.
UPGRADE LIST (menu) The following identifies the available upgrade features:
10 MBPS, 20 MBPS, 52 MBPS (The highest option installed will hide the
lower rates.)