Operating instructions

DMD20/DMD20 LBST Universal Satellite Modem User Interfaces
TM103 – Rev. 2.8 4-11
ADDRESS {xxxx}
Allows the user to enter the BUCs address for FSK
communications. Modem may be able to retrieve
address through the FSK Query for Address Test menu.
BUC TX ENABLE {Enable/Disable}
(Only available when the FSK Comm is Enabled)
Enables or Disables the BUC RF Output.
FSK TEST {NONE/LOOPBACK/CYCLE TX ENABLE/QUERY FOR
ADDRESS/PASS THRU}
(Only available when the FSK Comm is Enabled)
NONE:
This is the none FSK operational mode.
LOOPBACK:
The FSK will initiate an internal loopback test of the FSK
transmitter and receiver verifying that the modem
communication link is functioning properly.
CYCLE TX ENABLE:
The modem will initiate a test of the FSK between the
modem and BUC. The LBST will enable and disable the
BUC RF output and verify that the commands are
properly received and accepted by the BUC and the
modem. If communications are lost, LBST will initiate a
fault.
QUERY FOR ADDRESS
The modem will initiate a FSK query requesting BUC
address.
PASS THRU:
Allows the user to communicate with the BUC utilizing
the BUCs message protocol via the Remote ports
(Terminal, Web Browser, RLLP and SNMP).
AUPC (menu)
LOCAL AUPC (menu) The 'LOCAL AUPC CONFIGURATION' Menu contains
the local configuration parameters for the AUPC
Function.
AUPC MODE {DISABLED, NEAR SIDE, RADYNE, EFDATA}
DISABLED: Allows the user to enable or disable the
Local AUPC Function of the local modem.
EFDATA: Enables EFDATA Local AUPC Function. In
the event that the remote or local demodulator losses
lock, the output power level will adjust itself to the level
settings indicated in the 'REMOTE CL ACTION' Menu or
the 'LOCAL CL ACTION'.