User's Manual Part 1

Default RADWIN 2000 Settings Chapter 4
RADWIN 2000 User Manual Release 2.5.40 4-11
Default RADWIN 2000 Settings
The default settings of the RADWIN 2000 configuration parameters are listed in the second
column of Table 4-4 below. The third column shows the values we use in this manual for
illustrative purposes.
Using RADWIN Manager Spectrum View
Prior to running the Installation Wizard (Chapter 5), you may use the RADWIN Manager
Spectrum View utility.
The RADWIN Manager Spectrum View utility is an RF survey tool designed to support the link
installation prior to full link service activation. The tool provides comprehensive and clear
information enabling easier, faster and better quality installations.
To launch Spectrum View, go to the main window menu (Figure 4-11) and click Tools |
Spectrum View. A display similar to the following appears:
Table 4-4: Default Settings
Parameter Default Value Illustrative Value
Factory default band Product dependent 5.820GHz
ODU IP Address 10.0.0.120 192.168.1.101 and 102
Subnet Mask 255.0.0.0 255.255.255.0
Trap destination 0.0.0.0 0.0.0.0
RADWIN Manager log-on
passwords
Observer admin
Operator admin
Installer wireless
Link ID Link EBG_20561334
Link Name Name TPSF_BTT
Site 1 Site A
Site 2 Site B
Location (per site) Location A B
Name (per site) Name Here There
Contact (per site) Person John Mary
Link Password wireless-bridge
Rate Adaptive
Ethernet Configuration Auto Detect
Radio Link Failure Actions No action
Bridge or Hub mode Hub Mode, Aging time = 300 sec
Community values
Read-write – netman
Read-only – public