User's Manual Part 1

Installation Chapter 5
RADWIN 2000 User Manual Release 2.5.40 5-27
The optimum transmission rate for the selected services is evaluated.
Following a short delay for processing, Back and Next are enabled.
4. Click Next to continue.
Step 7, TDM Clock Configuration
The following dialog is displayed:
Figure 5-29: TDM Parameters Configuration (1)
 To configure TDM clock parameters:
1. For any individual port, click it. For the same parameters for all ports, click
the Select Maximum tag.
2. Click Configure. The following drop down list is displayed:
Note
The transmission rates used by RADWIN 2000 are shown in Table 5-3
above.
Note
• Select Maximum will select the maximum number of services that
were configured for the air interface for configuration
• Deselect All unconditionally deselects all of the services for configu-
ration
• Without selecting anything, right-clicking any port will cause the
appearance of the drop down list of Figure 5-30 below