Installation Guide

RADWIN5000InstallationGuide DQ0266610/A.01 3‐2
General SafetyPracticesandProvisions
3.1.4General
• Itisrecommendedthatinstallationofoutdoorunitsbecontractedtoaprofessional
installer
• Beforeworkingonequipmentconnectedtopowerlinesortelecommunicationlines,
removejewelryoranyothermetallicobjectthatmaycomeintocontactwithenergized
parts
• Useextremecar ewheninstallingantennasnearpowerlines
• Useextremecar ewhenworkingatheights
• WhenusinganACpowersourceforRADWINdevices,alwaysusetheACpoweradapter
suppliedbyRADWIN
• Usetherighttools!
• Donotmountanradiounitupsidedownorhorizontally.Doingthismayvoidyouprod‐
uctwarranty.
3.1.5InternalESDProtectioncircuits
RADWINequipmentisdesignedtomeettheETSI/FCC/Aus/NZ/CSAEMCandSafety
requirements.Tofulfilltheserequirements,thesystem'sTelecomlinesattheradiounit/PoE
areTransformer‐isolatedandincludeinternalESD(Electro‐Static‐Discharge)Protection
circuits.
WheninstallinganACpoweredSU:TomaintainOvervoltage(Installation)
CategoryII,installasuitablesurgesuppressordeviceinthebranchcircuit
tolimitexpectedtransientstoOvervoltageCategoryIIvalues.
ThelimitsarebasedonIEC60664andarealsolocatedinTable2Hof
UL60950(formains<=150V,thetransientratingis1500V;for150V<
mains<=300V,thetransientratingis2500V;andfor300V<mains<=
600V,thetransientratingis4000V).