Installation Guide
Table Of Contents
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Installation Steps
- 2.1 Prepare Laptop
- 2.2 Connect Laptop to Radio Unit
- 2.3 Update Connectivity Parameters of Radio Unit
- 2.4 Check items to be installed
- 2.5 Prepare Tools
- 2.6 Install Standard Mounting Kit
- 2.7 Install Mounting Kit for the SU PRO/AIR EMB
- 2.8 Mounting a Unit with the Standard Mounting Kit
- 2.9 Ground Radio Unit
- 2.10 Mounting the SU PRO/AIR EMB
- 2.11 Mounting the SU PRO/AIR INT
- 2.12 Mounting the Lightning Protection Units
- 2.13 Connect External Antenna (if applicable)
- 2.14 Waterproofing
- 2.15 Connect Radio (External Connections)
- 2.16 Check Connectivity to Radio
- 2.17 Activate Base Station
- 2.18 Align Subscriber Unit
- Chapter 3: Safety Practices and Provisions
- Appendix A: Wiring Specifications
- Appendix B: About Antennas
- Appendix C: Regional Notice: French Canadian
- Appendix A: Terminology
- Appendix E: Revision History
- Appendix F: Certified Antennas
- RADWIN Worldwide Offices
RADWIN5000InstallationGuide DQ0266610/A.01 2‐10
HBS:JETDUO,andJETAIR/PROradiounits InstallationSteps
3. LogontotheRADWINManageras
an“Installer”andent erthedefault
IPaddress(http://10.0.0.120)and
password:wireless.
4. FromtheRADWINManager,click
Activate,andfollowtheinstructionsin
thewizard.
5. Duringthecourseofthewizard,enter
thenewmanagementIPAddress,
SubnetMask,andDefaultGateway,
SectorID,operatingchannel,and
channelbandwidth.
6. Youwillbewarnedthatthedevicewillbereset.Ifallthevaluesarecorrect,click
OK.
7. Fromacommandline,pingradiounitusingnewIPaddresstoverifychange.
Onceyouarefinishedwiththestepsabove,disconnecttheradiounitandprepareitfor
deploymentinthefield.
2.3.4HBS:JETDUO,andJETAIR/PROradiounits
1. Ifyouhavenotalreadydoneso,connecttheradiotoyourPC/networkandvoltageviaits
inputport(“PoEIn”).
2. EnteritsIPaddressinawebbrowser(defaultvalue:10.0.0.120).
3. Enterusernameadminandpasswordnetwireless.
4. Fromthewindowthatappears,selectthebasestationunitbyplacinga
checkmarknexttoit,thenclickontheConfigureicon.
5. Fromthewindowthatappears,selectManagement‐>Network:
6. EnterthenewIPaddress,SubnetMaskandDefaultGatewayinaccordancewith
yourradioplan,thenclickSave.
Figure2‐8:JETDUOunit
Figure2‐8:JETAIR/PROunit