User's Manual

Chapter 4

Configuration

This chapter describes configuration procedures, which are performed

after the physical installation of the local and remote WinLink1000

units and the Installation Link wizard has been performed. A second

wizard is used to redefine the configuration parameters if necessary.

Both sites in the link are defined simultaneously.

The following parameters are configured via the configuration wizard:

• System parameters

• Frequency channel

• Air interface rate

• Service parameters

The following parameters are configured via the Configuration dialog

box.

• Transmit power

• Management and trap addresses

• Bridge mode

• Ethernet mode

• Community values

• External Alrams

4.1 Configuring the System Parameters

After installing the link, the system configuration can be modified.

Note

All parameter changes are automatically applied to both sides of the

link.

To change general parameters:

1. In the Main menu, click the Link Configuration button.

2. The Configuration wizard opens (

Figure

4-1

Configuring the System Parameters 4-1