User's Manual

Chapter 2 Installation and Setup WinLink1000 Installation and Operation Manual
Æ
To connect user equipment to the IDU:
1. Connect user E1/T1 traffic to the IDU panel RJ-45 port designated
TRUNK. There may be multiple Trunk ports available depending on
unit ordered.
Refer to
Appendix A for the connector pinout.
2. Connect user hub/router or any other compatible device to the IDU
panel
RJ-45 port designated LAN. There may be multiple LAN ports
available for connecting to different LANs depending on the IDU
unit ordered.
Refer to Appendix A for the connector pinout.
•
Use a straight cable for rou er connection. t
s
Do not connect two LAN ports to the same LAN, or flooding may occur.
Be sure not to misconnect LAN and TRUNK connection .
Notes
2-26 Connecting the User Equipment 9/18/2006 2:26:00 PM