User's Manual

Chapter 2 Installation and Setup WinLink1000 Installation and Operation Manual
Figure 2-16. TDM Parameters dialog box
•
This dialog box is available only with IDU-E units, it is activated a ter
TDM service was chosen in the previous Service dialog box. In Ethernet
only services, the TDM dialog box does not appear.
f
Note
Setting the T1 Line Code
The T1 line code can be set as B8Zs or AMI in the TDM Parameters
dialog box.
The default is B8ZS.
Æ
To change the line code
1. In the TDM Parameters dialog box, set the line code to B8ZS or AMI
as required.
2. Click Next to show the finish screen.
2-24 Installing the Link 9/18/2006 2:26:00 PM