User's Manual

WinLink1000 Installation and Operation Manual Chapter 2 Installation and Setup
Selecting the Service Parameters
The user defines the type of service required, Ethernet only or Ethernet
with TDM. The bandwidth remaining available for Ethernet if TDM
services are required is shown in the dialog box.
Figure 2-15. Installation Wizard, Services dialog box
Æ
To select the services:
1. In the Service dialog box, select one of the following:
 E1/T1 – E1/T1 data and Ethernet data.
The Ethernet BW field shows the remaining bandwidth in Mbps
available for Ethernet. The available bandwidth depends on the
number of E1/T1 ports selected.
 Ethernet only
2. Select the required transmission rate.
If Adaptive is selected WinLink1000 constantly monitors and
adjusts the transmission rate to ensure maximum throughput for
the link at the highest quality.
PM Installing the Link 2-21