User's Manual

WinLink1000 Installation and Operation Manual Chapter 2 Installation and Setup
WinLink1000 with Automatic Channel Select
Automatic Channel Select gives WinLink1000 the ability to change
frequency channels automatically if interference is detected on the
current operating channel.
Figure 2-14. Channel Select dialog box - Automatic Channel Select
3. Select the main frequency from the Operating Channel menu.
4. Select the required Bandwidth 5,10, or 20 MHz.
5. Click the check box if Automatic Channel Selection is required.
6. Click the check boxes in the Available Channels List of all the
allowable channels that can be automatically selected.
Selecting a new channel causes the system quality to change. The
quality bar shows the adjustment until the system finds the best
quality link.
7. If you are not satisfied with the channel that is selected
automatically, click Reselect Channel.
PM Installing the Link 2-19