User's Manual

Chapter 5 Diagnostics and Troubleshooting WinLink1000 Installation and Operation Manual
Rate
[Mbps]
Sensitivity
[dB]
48 -68
Q: Does WinLink1000 withhold any MAC Addresses?
A: The WinLink1000 is a layer 2 Bridge (VLAN transparent). The built-in
switch contains a MAC Address table up to 2047.
Q: Can I use any category 5e cable in order to connect the IDU and
ODU?
A: The cable should be suitable for outdoor use, and shielded Category
5e.
Q: What are the BER values expected in the WinLink1000 link?
A: 10-11 (according to BER sensitivity threshold)
Q: Does WinLink1000 use DSSS technique?
A: No, WinLink1000 uses the advanced OFDM technique.
Q: What are the main advantages of the WinLink1000 solution (e.g.,
wireline, wireless, etc.) over other possible alternatives?
A:
• Easy and intuitive installation using audio indication.
• Easy configuration using the management software of overall link
site-to-site, there is no need to travel between the two sites in
order to change the configuration.
• Easy migration between transition channels site-to-site.
• Full backup option – backup and restore using ini files.
• Very light ODU (1.5 kg).
• No RF loses between IDU and ODU.
• Robust Air Interface Layer 2 ARQ insures “error-free” Ethernet
service even in harsh conditions. Retransmit mechanism for TDM
esures low BER.
• Integrated up to 4 E1/T1 and Ethernet radio over one single
product.
5-20 Frequently Asked Questions