User's Manual
Table Of Contents
- WinLink(TM) 1000 Rev 3.0
- Notice
- Quick Start Guide
- Contents
- List of Figures
- List of Tables
- 2 Installation and Setup
- 3 Configuration
- 4 Operation
- 5 Diagnostics and Troubleshooting
- A Wiring Specifications
- B Mast and Wall Installation
- C Link Budget Calculator
- D TDM Clock Configuration
- Index
Chapter 5 Diagnostics and Troubleshooting WinLink 1000 Installation and Operation Manual
5-10 Frequently Asked Questions
Q: Can WinLink 1000 be managed and configured via Telnet?
A: No. Use only the WinLink 1000 software manager.
Q: After reselection Channel Reselection link is not established for long
time. How can I recover the link?
A: Click "cancel", then open the site configuration dialog and set the
unit to install mode. The remote side of the link shall enter install
mode on the installation channel.
Services
Q: What is the actual Ethernet data rate and maximum throughput?
A: The Max net throughput of the WinLink 1000 is Full Duplex 18
Mbps.
The WinLink 1000 is a symmetrical system
Q: Does WinLink 1000 withhold any MAC Addresses?
A: The WinLink 1000 is a layer 2 Bridge (VLAN transparent). The built
in switch contains a MAC Address table up to 2047.
Q: What are the BER values expected in the WinLink 1000 link?
A: 1E-10 (according to BER sensitivity threshold)
Antennas and Cables
Q: Can I use any category 5e cable in order to connect the IDU and
ODU?
A: The cable should be suitable for outdoor use, and shielded
Category 5e.
Competitve
Note