User's Manual
Table Of Contents
- WinLink(TM) 1000 Rev 3.0
- Notice
- Quick Start Guide
- Contents
- List of Figures
- List of Tables
- 2 Installation and Setup
- 3 Configuration
- 4 Operation
- 5 Diagnostics and Troubleshooting
- A Wiring Specifications
- B Mast and Wall Installation
- C Link Budget Calculator
- D TDM Clock Configuration
- Index
Chapter 3
Configuration
This chapter describes configuration procedures that are performed
after the link has been installed, synchronized, and the link
configuration has been performed by wizard.
WinLink 1000 has three types of products:
Note
•
Auto channel selection is not supported–Previous or Future release.
•
Auto channel selection supported–User can enable/disable auto
channel configuration.
•
DFS–Auto channel is mandatory.
3.1 Performing Configuration of WinLink 1000
After installing the link, the system configuration can be altered.
Performing Configuration of WinLink 1000 3-1