User's Manual

WinLink 1000 Installation and Operation Manual Chapter 2 Installation and Setup
Installation and Setup 2-17
When the wireless link is established between the site A and
site B units, the Link Status indication bar of the Main menu is
within the green area.
18. Verify that the radio signal strength (RSS) in the Main menu is
according to expected results.
Connecting the User Equipment
The IDU-E is a standalone desktop, wall-mounted unit. This unit has
both front and rear panel connections.
The optional IDU-C is a standalone rack mounted unit. This unit has
only front panel connections.
Figure 2-2 illustrates the typical panels of the IDUs.
Î
To connect user equipment to the IDU:
1. Connect user E1/T1 traffic to the appropriate IDU panel RJ-45 port
designated Trunk. Refer to Appendix A for the connector pinout.
2. Connect user hub/router or any other compatible device to the
appropriate IDU panel RJ-45 port designated LAN. Refer to
Appendix A for the connector pinout.
IDU-C has an integrated LAN switch that provides 2 ports of
10/100BaseT. The integrated LAN switch does not support spanning
tree.
The two LAN ports can be connected to two separate LAN segments,
but connection of both LAN ports to the same LAN segment will create
a loop that floods the network. Therefore, this configuration is
prohibited.
Note