User's Manual
Table Of Contents
- WinLink(TM) 1000 Rev 3.0
- Notice
- Quick Start Guide
- Contents
- List of Figures
- List of Tables
- 2 Installation and Setup
- 3 Configuration
- 4 Operation
- 5 Diagnostics and Troubleshooting
- A Wiring Specifications
- B Mast and Wall Installation
- C Link Budget Calculator
- D TDM Clock Configuration
- Index
WinLink 1000 System 2-1
Chapter 2
Installation and Setup
This chapter describes installation and setup procedures for WinLink
1000 system.
After installing the unit, refer to Chapter 3 for configuration
instructions and Chapter 4 for operation instructions.
In case a problem is encountered, refer to Chapter 5 for test and
diagnostic instructions.
Internal settings, adjustment, maintenance, and repairs may be
performed only by a skilled technician who is aware of the hazards
involved.
Always observe standard safety precautions during installation,
operation, and maintenance of this product.
The operator of the spread spectrum intentional radiator or, if the
equipment is professionally installed, the installer is responsible for
ensuring that the system is used exclusively for fixed, point-to-point
operations . The instruction manual furnished with the intentional
radiator shall contain language in the installation instructions
informing the operator and the installer of this responsibility.
WinLink 1000 has three types of products:
•
Auto channel selection is not supported–Previous or Future release.
•
Auto channel selection supported–User can enable/disable auto
channel configuration.
•
DFS–Auto channel is mandatory.
2.1 WinLink 1000 System
WinLink 1000 system comprises the following units:
• Outdoor Unit (ODU): The ODU has 2 configurations: ODU with
integrated antenna and ODU with N-Type connector for connection
Warning
Note
Warning