User's Manual

WinLink User and Installation Guide Version 1.770 K-168

The Air Section is includes, in the top level, configuration data such as

frequency and rate and a sub-section for air interface performance

data.

IDU MIB

The IDU MIB is divided into three sub sections: Admin, Service and

TDM.

The Admin section includes data about the software and hardware

revisions of the product. Note the IDU is managed via the ODU and

therefore no IP configuration is available for this unit.

The service MIB is used both to configure the TDM services (either E1

or T1) and monitor the status of the services activation.

The TDM section includes two tables. The first is used for monitor

trunks status and configure trunk modes, such as line coding and loop-

back, the second table includes the trunk performance data.

General MIB

The general MIB include a single generic parameter that use be all

traps as a trap description parameter.

MIB Parameter

The following section describes all the MIB parameters. The MIB

parameters follow the following naming convention:

For each of the configuration and control parameters (parameters with

read-write access), "Effective" column describes when the new value is

effective. It is highly recommended to perform the appropriate action

in order to make the values affective immediately after changing the

value. In cases that a change is required in both sides of the link, it is

recommended to change both sides of the link and then only perform

the action.