User's Manual Part 1

Chapter 4 Configuration WinLink 1000 Installation and Operation Manual

3. If you are not satisfied with the channel that is selected

automatically, click Reselect Channel.

A new channel will be selected from one of the Available

Channels that have been defined.

Note

The reselection process may take a few minutes.

4. Click Next.

The maximum rate is selected according to the link conditions

The quality bar shows the adjustment until the system finds the

best quality link.

7. Click Next.

The Service Parameters dialog box appears.

WinLink 1000 BRS Version

Both sites in a BRS Link must be configured identically.

Any changes to the frequency settings cause the link to re-

synchronize. A short loss of servi e will occur during re-

synchronization.

Not

To Configure BRS Channel Settings

1. Set the Band Plan.

2. Select the Bandwidth required,

Single Band

Double Band

3. Select the Frequency from the pull-down menu.

4. Click Next. The system is re-synchronized to the changes.

4-8 Selecting Channels