User's Manual Part 1

WinLink 1000 Installation and Operation Manual Chapter 2 Installation and Setup
Figure 2-17. Installation Wizard, Services dialog box
Æ
To select the services:
 In the Service dialog box, select one of the following:
 E1/T1 – E1/T1 data and Ethernet data.
The Ethernet BW field shows the remaining bandwidth in Mbps
available for Ethernet. The available bandwidth depends on the
number of E1/T1 ports selected.
 Ethernet Only
5. Select the required transmission rate.
If Adaptive is selected WinLink 1000 constantly monitors and
adjusts the transmission rate to ensure maximum throughput for
the link at the highest quality. ACCESS versions are preset to
adaptive and the rate selection is disabled.
6. Click Next.
If TDM services were selected, then the TDM parameters dialog
box appears, (see
Figure 2-18 ).
Installing the Link 2-25