Manualshelf

User's Manual Part 1

ManualsBrandsRadwin ManualsElectronicsODU Transmitter
31323334353637383940
Chapter 2 Installation and Setup WinLink 1000 Installation and Operation Manual
6.
Slowly turning the site A ODU back towards the position of Site B,
listen to the beeps until the best signal is reached. See
7. Figure 2-7 for the beeper signals.
Figure
2-7. Beeper Sequence for ODU Alignment
Note
•
Three beeps and a pause is the best signal
Two beeps and a pause, signal quality increased
One beep and pause is no signal change
Any other signal detects no signal between ODUs.
8. Secure the site A ODU to the mast/wall.
9. At site B, adjust the ODU slowly whilst listening to the beeper
sequence until the best signal is attained.
10. Secure the site B ODU to the mast/wall.
11. Monitor the link quality for about 15 minutes to verify stability.
2.11 Starting the WinLink 1000 Manager Software
Æ
To start the WinLink 1000 Manager:
1. Connect the management station to the LAN.
2. Double-click the WinLink 1000 Manager icon on the desktop, or
click Start > Programs > WinLink 1000 Manager.
2-12 Starting the WinLink 1000 Manager Software