User's Manual Part 1

Chapter 2 Installation and Setup WinLink 1000 Installation and Operation Manual

2. Connect the AC/DC converter 3-prong plug to a mains outlet.

The unit turns on automatically upon connection to the mains.

The green PWR indicator turns on, and the IDU indicator blinks

orange for approximately 40 seconds during startup. See

Normal Indicators

section in Chapter 3.

After approximately 20 seconds the ODU starts beeping. The

beeps continue until the ODUs are aligned and the link set up.

3. Wait for approximately one minute, then repeat for Site B.

Connecting Power to an IDU-C

AC power is supplied to the WinLink 1000 IDU-C through a standard

3-prong plug.

AC power should be supplied via a 1.5m (5 ft) standard power cable

terminated by a standard 3-prong socket. A cable is provided with the

unit.

To connect AC power to an IDU-C:

1. Connect the power cable socket to the power connector on the

WinLink 1000 front panel.

2. Connect the power cable plug to the mains outlet.

The unit turns on automatically upon connection to the mains.

To connect DC power to an IDU-C

A special IEC 60320 adapter for-48 VDC power connection is supplied

with the unit.

Connecting Power to an O-PoE

AC power is supplied to the O-PoE via a 3m (10 ft) 3-prong AC cable

attached to the unit (pigtail). The AC cable is provided with no

termination.

To connect AC power to an O-PoE:

Connect the power cable to a protected/shielded AC mains outlet. The

AC mains outlet should be provided with circuit breaker rated 5A

according to the local national electrical code.The unit will be turned

on automatically upon connection to the mains.

2-10 Connecting the Power