User's Manual Part 1

WinLink 1000 Installation and Operation Manual Chapter 2 Installation and Setup

• Graphics: Card and monitor that support 1024×768 screen

resolution

with 16 bit color

• Operating system: Windows 2000/XP

• Microsoft Explorer 5.01 or later.

Installing the Software

To install the WinLink 1000 management program:

1. Insert the CD-ROM into your CD-ROM drive.

2. The autorun feature starts to install the software automatically.

If the installation does not start automatically, run setup.exe.

3. Follow the on-screen instructions of the installation wizard to

complete setup of the WinLink 1000 Management program in the

desired location.

Any PC running the WinLink 1000 management application can be used

to configure WinLink 1000 units.

2.9 Connecting the Power

•

Before connecting any cable, the protective earth terminals of the

AC/DC adapter must be connected to the protective ground conductor

of the mains power cord. If you are using an extension cord (power

cable) make sure it is grounded as well.

Any interruption of the protective (grounding) conductor (inside or

outside the instrument) or disconnecting of the protective earth

terminal can make this unit dangerous. Intentional interruption is

prohibited.

Warning

Connecting Power to an IDU-E

Power is supplied to the WinLink 1000 IDU-E via an external AC/DC

converter, which receives power from a 100–240 VAC source and

converts it to -48 VDC.

To connect power to the IDU-E:

1. At site A, connect the 2-pin connector of the AC/DC converter to

the 2-pin DC power connector on the IDU-E rear panel.

Connecting the Power 2-9