User's Manual Part 1

Chapter 2 Installation and Setup WinLink 1000 Installation and Operation Manual
conductor or to a grounded mast. For grounding the O-PoE, connect
the grounding cable from the dedicated earth terminal (screw at the
side of the enclosure) to an external protective ground conductor or to
a grounded mast.
Only a qualified person using the proper safety equipment should
climb the antenna mast. Only trained professional installers should be
used when installing or dismantling ODUs and masts.
Æ
To mount the ODU or O-PoE:
1. Verify that the ODU or O-PoE mounting brackets are properly
grounded.
2. Mount the ODU or O-PoE unit onto the mast or wall. Refer to
Appendix B for the ODU and O-PoE mounting instructions.
3. Connect the ground cable to the chassis point on the ODU.
4. Attach the ODU-IDU cable to the ODU RJ-45 connector. If making
own ODU-IDU cable, refer to
Appendix A for the connector pinout.
5. Secure the cable to the mast or brackets using UV-rated cable ties.
6. Repeat the procedure at the remote site.
•
Note
Do not tightly secure the ODU to its mounting brackets until the
alignment process of the antenna is complete.
When installing the ODU, check that there are no direc obstructions in
front of the ODU or interference from man-made obs acles.
t
t
For O-PoE UL Listed parts and components must be used for
installation. Use UL listed devices having an environmental rating equal
to or better than the enclosure rating to close all unfilled openings.
Caution
2-6 Mounting the ODU or O-PoE