User's Manual Part 1

Chapter 1 Introduction WinLink 1000 Installation and Operation Manual
link, and power status. For a detailed description of the front panel
LEDs, see
Chapter 3 .
The rear panel of the IDU includes the connectors for power, WAN,
LAN, E1/T1, and the ODU. The wiring specifications are detailed in
Appendix A . The rear panel LEDs are described in Chapter 3 .
IDU-C
The IDU-C front panel includes four LEDs that display the status of
E1/T1and, wireless link, self-test results, and ODU-to-IDU link. For a
detailed description of the front panel LEDs, see Chapter 3 .
ODU
ODU includes a power connector, which receives -48 VDC, and RJ-45
for Ethernet traffic from the IDU. The ODU is attached to a mast using a
special mounting kit, which is supplied with the unit.
The ODU can be used with an integrated antenna, as illustrated in
Figure 1-2 , or with an external antenna. If an external antenna is to be
used, then the ODU is supplied fitted with an N-type connector.
O-PoE
O-PoE includes an AC power cable with no termination which can be
connected to100-220VAC outlet. The designated PoE connector is
connected to an ODU via a shielded CAT-5e twisted pair cable and
delivers Ethernet traffic with 48VDC power towards the ODU. The
designated ETH connector is connected via a shielded CAT-5e twisted
pair cable which receives and delivers Ethernet traffic. The wiring
specification for the twisted pair cable is detailed in
Appendix A
The O-PoE is attached to a mast using a special mounting kit, which is
supplied with the unit.
•
To connect the ETH port from O-PoE to a PC, a crossed LAN cable must
me used. See
Appendix A .
Note
1.3 Functional Description
WinLink 1000 system comprises of the following units:
1-8 Functional Description