User's Manual Part 1

Installation and Operation Manual Quick Start Guide

To connect AC power to an IDU-C:

1. Connect the power cable socket to the power connector on the

WinLink 1000 front panel.

2. Connect the power cable plug to the mains outlet.

The unit will be turned on automatically upon connection to the

mains.

To connect DC power to an IDU-C

A special IEC 60320 adapter for -48 VDC or -24 VDC power connection

is supplied with the unit.

Connecting Power to an O-PoE

AC power is supplied to the O-PoE via a 3m (10 ft) 3-prong AC cable

attached to the unit (pigtail). The AC cable is provided with no

termination.

To connect AC power to an O-PoE:

Connect the power cable to a protected/shielded AC mains outlet.

The unit will be turned on automatically upon connection to the mains.

To maintain Overvoltage (Installation) Category II, install a suitable

surge suppressor device in the branch circuit to limit expected

transients to Overvoltage Category II values.

The limits are based on IEC60664 and are also located in Table 2H of

UL60950 (for mains ≤ 150V, the transient rating is 1500V

for 150V < mains ≤ 300V, the transient rating is 2500V;

and for 300V < mains ≤ 600V, the transient rating is 4000V).

Warning

5. Connecting the User Equipment

To connect user equipment to the IDU:

1. Connect the user equipment (such as PBX) to the IDU RJ-45 port

designated Trunk:

 On the rear panel of the IDU-E

WinLink 1000 Connecting the User Equipment 7