User's Manual Part 1

WinLink 1000 Installation and Operation Manual Chapter 4 Configuration
Command Explanation
reboot Reset both the IDU and the ODU. The user shall
be prompt that the command will reset the card
and that he has to reconnect the telnet session
after TBD seconds.
help Displays the available commands
Figure 4-20 shows the available Telnet commands via the Help
command.
Hello admin, welcome to ODU Management CLI!
+-----------------------------------------------------------+
Software Revision 1.700_b900_Feb 11 2007
+-----------------------------------------------------------+
admin@10.103.6.1-> help
display inventory
display management
display link
display ethernet
display tdm
display ntp
set ip <ipaddr> <subnetMask> <gateway>
set trap <index:1-10> <ipaddr> <port:0-65535>
set readpw <oldpasswd> <passwd>
set writepw <oldpasswd> <passwd>
set trappw <oldpasswd> <passwd>
set buzzer <mode:0=OFF,1 =ON>
set tpc <power:Value between minimal TX power, and maximal TX power>
set bridge <mode:0=Bridging OFF,1= Bridging ON >
reboot
help
Command "help" finished OK.
Figure 4-20. Telnet Management Screen
Configuration via Telnet 4-39