User Manual

AirMux-200 Installation and Operation Manual Chapter 4 Operation
Managing AirMux-200 4-5
§ Logging off AirMux Manager (Log Off button)
§ Exiting AirMux Manager (Exit button)
• Menu bar – functions are similar to those of the toolbar.
• Link Parameters – summarizes information on the radio frequency,
IP bandwidth, type of TDM service, number of assigned E1 or T1
timeslots, and IP details of the local and remote AirMux-200 units.
• Local and Remote Statistics – monitor traffic between local and
remote devices and collect following statistics:
§ Local/remote received traffic rate (in kbps)
§ Local/remote received frames rate (in fps)
§ Radio link status
§ E1 or T1 link status
§ Radio signal strength (RSS) in dBm
§ Signal-to-noise ratio (SNR) in dB
§ Bit error rate.
• Event log – stores alarms generated by local and remote units.
ä
To change link configuration parameters:
1. In the Main menu, click Configure Link.
The Configure Link wizard appears (see Figure 4-3). See Chapter
3 for configuration details.
2. Click Next.
3. In the General Parameters dialog box enter a new link name,
locations of the local and remote ODUs.
4. Click Next.
5. Continue through the configuration wizard and define the Channel,
Rate and Services of the link.
6. Once you finish changing configuration parameters, click Finish.
Both AirMux-200 units are reset automatically (initially the
remote unit, then the local one).