User Manual

Performing Configuration of AirMux-200 3-1
Chapter 3
Configuration
This chapter describes configuration procedures, which is performed
after the physical installation of the local and remote AirMux-200
units.
3.1 Performing Configuration of AirMux-200
After physical installation of the local and remote AirMux-200 units,
perform initial configuration of the system.
ä
To perform initial setup:
1. Power up the local IDU (see Connecting the Power in Chapter 2).
Wait for about 1 minute.
2. Power up the remote IDU.
3. Connect the management station to the LAN.
Any PC running the AirMux-200 management application can be used
to configure AirMux-200 units.
ä
To start AirMux manager:
1. From the Start menu, point to Programs, point to AirMux Manager,
and then click AirMux Manager.
The password/IP request dialog appears.
2. Enter IP + password – airmux.
The AirMux Manager Main menu is displayed (see Figure 3-1).
The system is factory installed with the settings of the system ordered,
therefore the Install Link button is disabled.
Note