User Manual

Chapter 2 Installation and Setup AirMux-200 Installation and Operation Manual

2-4 Installation and Setup

Installing AirMux-200 Management Software

AirMux-200 management application is distributed on CD-ROM as an

executable file. The application operates on a PC under any

Windows 98/2000/NT/XP operating system.

To install the AirMux-200 management program:

1. Insert the CD-ROM into your CD-ROM drive.

2. Run Airmux.exe from the CD-ROM drive.

3. Follow the onscreen instructions of the installation wizard to

complete setup of the AirMux-200 management program in the

desired location.

Connecting the ODU to the IDU

The ODU cable conducts all the user traffic between the IDU and the

ODU. The ODU cable also provides -48 VDC supply to the ODU. The

maximum length for one leg of the ODU cable is 100m (328 ft).

The ODU cable is supplied assembled with RJ-45 connectors, at the

length specified when ordering. Spare RJ-45 connectors are supplied

for use if necessary.

1. Route the cable from the ODU location into the building, leaving

some spare. Secure the cable along its path.

2. Connect the ODU cable to the RJ-45 connector on the IDU rear

panel designated WAN. Figure 2-2 illustrates a typical panel of the

IDU.

Figure 2-2. IDU Rear Panel

Mounting and Aligning the ODU

The ODU is the transmitting and receiving element of the AirMux-200

system. The ODU can be mounted on a mast or a wall. In both

installations, the supplied mounting kit is used to secure the ODU.

Appendix B describes the mast/wall installation instructions.