User Manual

AirMux-200 Installation and Operation Manual Quick Start Guide
Operating AirMux-200 3
Do not stand in front of a live radio terminal.
2. Align the local ODU in the direction of the remote ODU. Turn the ODU
slowly using the buzzer beep sequence until optimal alignment is
achieved:
3. Repeat step 2 for the remote ODU to complete the alignment
procedure.
4. Make sure that the management station is properly connected to the
local IDU, and the AirMux Manager application is running.
5. Open the installation wizard and follow the installation steps
6. After selection of the radio channel and the link rate, verify the link
quality is at least in the yellow area for Ethernet service and in the
green area for TDM service.
Try to achieve the best possible link quality values. In case of radio link
loss, verify the ODU alignment, or change the radio channel in both sides
of the link. When the radio link resumes continue the installation process.
7. Monitor the link quality for about 15 minutes to verify stability.
8. Permanently attach the local and remote ODU to the mast/wall.
Performing Indoor Installation
ä
To connect user equipment to the IDU:
1. Connect user mux or PBX to the IDU rear panel RJ-45 port designated
Trunk.
2. Connect user hub/router or any other compatible device to the IDU
rear-panel RJ-45 port designated LAN.
2. Operating AirMux-200
AirMux-200 requires no operator attention once installed, with the
exception of occasional monitoring of front panel indicators and statistics
data. Intervention is only required when AirMux-200 must be configured
to its operational requirements or diagnostic tests are performed.
Note